CCENT CCNA CCNA routing and switching Certificate Cisco

You are configuring HSRP for VLAN 13. You want its primary default gateway to be the router RouterOxford1 and secondary default gateway be RouterCambridge2.​What should you consider when configuring HSRP for the router RouterOxford1?

You are configuring HSRP for VLAN 13. You want its primary default gateway to be the router RouterOxford1 and secondary default gateway be RouterCambridge2.
What should you consider when configuring HSRP for the router RouterOxford1?

  • 1- Ensure that you specify RouterCambridge2 has a lower priority than RouterOxford1.
  • 2- To ensure RouterOxford1 always has priority, use the IP address of the physical interface of RouterOxford1 for the virtual IP address.
  • 3- Ensure that you use the same group number, for example 13, for all your configuration commands
  • 4- Ensure that pre-emption is disabled on both routers.




  • The correct answer is:

  • 1- Ensure that you specify RouterCambridge2 has a lower priority than RouterOxford1. 
  • 3- Ensure that you use the same group number, for example 13, for all your configuration commands 

HSRP provides high network availability by providing redundancy for IP traffic from hosts on networks. In a group of router interfaces, the active router is the router of choice for routing packets; the standby router is the router that takes over the routing duties when an active router fails or when preset conditions are met.

Routers in an HSRP group can be any router interface that supports HSRP, including Catalyst 3750-X or 3560-X routed ports and switch virtual interfaces (SVIs)..

Practice Cisco ICND2 v3.0(200-105) exam or IT skills
Practice Cisco ICND2 v3.0(200-105)

Leave a Reply